Origami Jumping Frog Instructions

Origami Jumping Frog

The Origami Jumping Frog is really easy to make... To make the frog jump to its best potential, use paper that's a bit thicker. You will need to use rectangular paper for this model

For a printable .pdf version of the jumping frog instructions, click here.
You will need Adobe Reader installed on your computer in order to open the .pdf file. You can get Adobe Reader here

1. Start with a rectangular sheet of paper, white side up.

Fold it in half, and open out again

2. fold both top corners to the opposite edge of the paper then unfold. Your creases should look like this.

3. Where the diagonal creases meet in the middle, fold the paper backwards, crease well and open.

4. Hold the paper at the sides, bring these points down to the centre line, then flatten. The creases should do most of the work here!

5. Fold the uppermost triangles up to the top point.

6. Fold sides in to the centre line.

7. Fold bottom of model upwards so the end sits in the centre of the top diamond.

8. Now fold the same part downwards, in half.

Turn over, your Jumping Frog is finished!

To make him jump, press down on his back as shown.

Browse other models like the origami jumping frog

Origami Jumping Frog

New! Comments

Have your say about this page! Leave me a comment in the box below.

Popular Designs






Jumping Frog